The hybrid vehicle control ECU monitors its internal operation, it will set DTCs and perform fail-safe control when it detects the following malfunction.
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P31B4 | 123 | The hybrid vehicle control ECU detects an excessive charge current signal. | Hybrid vehicle control ECU |
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Check if DTCs are output.
| Result | Proceed to |
|---|---|
| P31B4-123 only is output. | A |
| DTCs other than P31B4-123 are output. | B |
Turn the power switch off.
A
B
(See pageEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>DIAGNOSTIC TROUBLE CODE CHART)