Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HV BATTERY
RM2070E _51 Engine / Hybrid System _061906 HYBRID / BATTERY CONTROL _0301578 HV BATTERY N

HYBRID / BATTERY CONTROL  HV BATTERY  DISCHARGING  


PROCEDURE

Hide 1. DISCHARGING (WHEN USING THE LI-ION BATTERY DISCHARGER)

NOTICE:

Make sure to observe the following points when using the Li-ion battery discharger.

·

Set it in a secure, flat place.

·

Set it in a dry place protected from dust and water.

·

Set it in a position where illumination of the LED indicators can be observed.

·

Do not block the ventilation holes or cooling fans.



a.

Select Li-ion battery connection cables

i.
N101003

Confirm the type of the Li-ion battery connection cable as indicated by the tag shown in the illustration. (Type: TM4216-21)



b.

Install Li-ion battery connection cable

i.
N101004

Set the Li-ion battery discharger as shown in the illustration.


ii.
N101005E01
2.08,1.381 2.265,1.589 0.185,0.208 10 *1 2.237,1.368 2.347,1.039 false

Connect the Li-ion battery connection cable connector (A) to the Li-ion battery discharger connector (A).

NOTICE:

Make sure that the connector is connected securely.


Text in Illustration
*1 Connector A


iii.
N101006E01
1.575,1.493 2.097,1.485 false 2.134,1.403 2.388,1.586 0.254,0.183 10 *1

Connect the Li-ion battery connection cable connector (B) to the Li-ion battery discharger connector (B).

NOTICE:

Make sure that the connector is connected securely.


Text in Illustration
*1 Connector B


iv.
N101020

Set the Li-ion battery discharger as shown in the illustration.

HINT:

The Li-ion battery discharger is set on its side so that the ventilation holes will not be blocked.




c.

Connect Li-ion battery connection cable

i.
N101010

Connect the Li-ion battery connection cable connectors (orange) to the 4 high-voltage connectors (orange) of the HV battery.


ii.
N101025

Confirm that all of the LED indicators are illuminated as shown in the following table.

CAUTION:

If all of the LED indicators of the Li-ion battery discharger listed in the following table are not illuminated, discharge using the Li-ion battery discharger cannot be performed on the HV battery. Make sure to soak the HV battery in a saltwater solution to complete discharging.


LED Indicator Illumination Status (When discharge has started normally)
LED Indicator No. LED Indicator Illumination Status LED Indicator No. LED Indicator Illumination Status LED Indicator No. LED Indicator Illumination Status
1 Illuminated 2 Illuminated 3 Illuminated
4 Illuminated 5 Illuminated 6 Illuminated
7 Illuminated 8 Illuminated 9 Illuminated
10 Illuminated 11 Illuminated 12 Illuminated
13 Illuminated 14 Illuminated 15 Not illuminated
16 Not illuminated 17 Not illuminated 18 Not illuminated
19 Not illuminated 20 Not illuminated 21 Not illuminated
22 Not illuminated 23 Not illuminated 24 Not illuminated
25 Illuminated 26 Illuminated 27 Illuminated
28 Illuminated 29 Illuminated 30 Illuminated
31 Illuminated 32 Illuminated 33 Illuminated
34 Illuminated 35 Illuminated 36 Illuminated
37 Illuminated 38 Illuminated 39 Not illuminated
40 Not illuminated 41 Not illuminated 42 Not illuminated
43 Not illuminated 44 Not illuminated 45 Not illuminated
46 Illuminated 47 Illuminated 48 Illuminated
49 Illuminated 50 Illuminated 51 Illuminated
52 Illuminated 53 Illuminated 54 Illuminated
55 Illuminated 56 Illuminated 57 Illuminated
58 Illuminated 59 Illuminated 60 Not illuminated
61 Not illuminated 62 Illuminated 63 Illuminated
64 Illuminated 65 Illuminated 66 Illuminated
67 Illuminated 68 Illuminated 69 Illuminated
70 Illuminated 71 Illuminated 72 Illuminated
73 Illuminated 74 Illuminated 75 Illuminated


iii.

Confirm that the cooling fans operate.

N101026E02
2.427,0.375 3.396,0.375 false 4.563,0.375 3.802,0.375 false 3.521,0.292 3.813,0.646 0.292,0.354 10 false *1

Text in Illustration
*1 Cooling Fans

HINT:
·

To discharge the HV battery completely, continue discharging for at least 1 hour after the LED indicators have turned off.

·

Discharge of a fully charged HV battery will complete within 5 hours (including 1 hour waiting time after the LED indicators have turned off).





d.

Confirm discharge completion

i.

Confirm that all of the LED indicators of the Li-ion battery discharger have turned off.


ii.

Continue to discharge the battery for 1 hour after all of the LED indicators of the Li-ion battery discharger have turned off.



e.

Disconnect Li-ion battery connection cable

i.
N101027

Disconnect the Li-ion battery connection cable connector (orange) from the 4 high voltage connectors (orange) of the HV battery.

NOTICE:

Make sure to install a shorting connector within 1 minute of disconnecting the Li-ion battery connection cable, as the HV battery voltage may recover unexpectedly.




f.

Remove Li-ion battery connection cable

i.
N101024

Set the Li-ion battery discharger as shown in the illustration.


ii.
N101012E01
1.606,1.402 2.195,1.398 false 2.222,1.3 2.559,1.533 0.338,0.233 10 *1

Disconnect the Li-ion battery connection cable connector (B) from the Li-ion battery discharger connector (B).

Text in Illustration
*1 Connector B


iii.
N101013E01
2.34,1.024 2.187,1.374 false 2.089,1.401 2.340,1.611 0.250,0.211 10 *1

Disconnect the Li-ion battery connection cable connector (A) from the Li-ion battery discharger connector (A).

Text in Illustration
*1 Connector A



Hide 2. DISCHARGING (WHEN USING THE SALT WATER SOLUTION)

NOTICE:
·

When discharging using saltwater solution, first add a measured amount of water to the container, and then add the concentrated saltwater solution.

·

Calculate the saltwater concentration based on the measured volume of water in the container so that a 1% saltwater solution will be made after adding the concentrated saltwater solution to the water in the container where HV battery is set.



a.

Prepare HV battery

CAUTION:

Be sure to wear insulated gloves and protective goggles.


i.
A288999E01
0.105,0.11 0.434,0.465 0.330,0.355 10 *a 2.031,1.762 2.917,1.884 2.917,1.884 2.003,2.521 false 2.966,1.803 3.240,2.158 0.274,0.355 10 *b

Set the HV battery in the container (A).

Text in Illustration
*a Example
*b Container (A)

NOTICE:
·

Since the HV battery is very heavy, 2 people are needed to set the HV battery.

·

Perform discharging in a well-ventilated area.

·

Perform discharging in a dry area protected from rain.





b.

Prepare to discharge (Add water to container)

CAUTION:

Be sure to wear insulated gloves and protective goggles.


i.
A294871E02
2,0.719 2.26,0.469 2.26,0.469 2.521,0.469 false 0.177,0.125 0.677,0.76 0.5,0.635 10 false *a 2.563,0.396 3.063,1.031 0.5,0.635 10 false *b

Measure the water capacity of the container (B).

Text in Illustration
*a Example
*b Container (B)

HINT:

Water capacity of the container (B) is assumed as X (liter).



ii.
A296354E02
0.771,0.885 0.865,0.885 0.865,0.885 1.01,1.156 false 0.99,3.354 1.094,3.354 1.094,3.354 1.24,3.615 false 0.427,3.031 0.531,3.031 0.531,3.031 0.677,3.281 false 0.906,0.51 1.01,0.51 1.01,0.51 1.167,0.76 false 2.365,0.177 2.917,0.177 false 2.667,2.76 2.354,2.76 false 0.063,0.073 0.417,0.427 0.354,0.354 10 false *a 0.583,0.792 0.938,1.146 0.354,0.354 10 false *b 0.802,3.281 1.156,3.635 0.354,0.354 10 false *b 0.24,2.948 0.594,3.302 0.354,0.354 10 false *c 0.729,0.417 1.083,0.771 0.354,0.354 10 false *c 2.948,0.083 3.302,0.438 0.354,0.354 10 false *d 2.167,2.677 2.521,3.031 0.354,0.354 10 false *d

Using the container (B), add water to the container (A) until the HV battery is completely submerged.

Text in Illustration
*a Example
*b Water Surface
*c Container (A)
*d Container (B)

NOTICE:

Make sure to record the times the container (B) was filled with water to add water to the container (A).



iii.

Using the following formula, calculate the amount of water added to the container (A).

Amount of water added to the container (A):

Y (liter) = Water capacity of the container (B) x Number of times the container (B) was filled with water to submerge the HV battery


HINT:

Amount of water added to the container (A) is assumed as Y (liter).




c.

Prepare saltwater solution

i.
A294873E01
1.911,0.706 2.25,0.367 2.25,0.367 2.661,0.367 false 0.113,0.065 0.490,0.392 0.377,0.327 10 *a 2.669,0.286 3.046,0.612 0.377,0.327 10 *b

While measuring the amount of water, fill about half of the container (B) with water.

Text in Illustration
*a Example
*b Container (B)

HINT:

Amount of water added to the container (B) is assumed as Z (liter).



ii.

Calculate the amount of salt to be added to the container (A) so that a 1% salt water solution will be made.

Amount of Salt:

Amount of salt (kg) = (Y (liter) + Z (liter)) x 0.01



iii.
A294872E01
1.67,0.689 2.133,0.226 2.133,0.226 2.328,0.226 false 2.363,0.136 2.683,0.382 0.321,0.245 10 *b 0.05,0.047 0.370,0.293 0.321,0.245 10 *a

Add the calculated amount of salt to the container (B) and stir it thoroughly.

Text in Illustration
*a Example
*b Container (B)



d.

Add saltwater solution

CAUTION:

Be sure to wear insulated gloves and protective goggles.


i.
A289001

Add the concentrated saltwater solution to the container (A).



e.

Discharge

i.

Leave the HV battery as is for 24 hours or more until discharge is complete.

CAUTION:
·

Do not place a lid on the container.

·

Make sure to leave the HV battery and container as is for 24 hours or more.

·

Display a warning sign to inform others that discharge is being performed.





f.

Confirm discharge completion

i.

Check that bubbles are not forming in the container.

NOTICE:

If bubbles are forming, discharge may not be completed yet. Do not place a lid on the container.




g.

Display a warning sign such as "DO NOT TOUCH! (DISCHARGE BEING PERFORMED) to inform others. Make a copy of the warning sign and place it near the HV battery being discharged.

A289826