Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › WATER PUMP WITH MOTOR
RM2070E _51 Engine / Hybrid System _061906 HYBRID / BATTERY CONTROL _0301579 WATER PUMP WITH MOTOR A

HYBRID / BATTERY CONTROL  WATER PUMP WITH MOTOR  REMOVAL  


PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide G9200 3.REMOVE INVERTER WITH CONVERTER ASSEMBLY

Hide G9040 6.REMOVE INVERTER WATER PUMP ASSEMBLY

a.
A248081

Disconnect the 2 water hoses and connector.

NOTICE:
·

Put pieces of cloth into the pipes and in the disconnected hoses to prevent foreign matter from entering the inverter water pump and cooling system.

·

Apply insulating tape to the connectors of the wire harness and inverter water pump assembly with motor to prevent the entry of coolant.




b.
A248082

Remove the 3 bolts and the inverter water pump assembly with the water pump bracket.