Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › COMBINATION SWITCH › 2012.03–2013.08
RM2070E _51 Engine / Hybrid System _061906 HYBRID / BATTERY CONTROL _0301585 COMBINATION SWITCH A

HYBRID / BATTERY CONTROL  COMBINATION SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 58804A 9.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

Hide 84970 10.REMOVE COMBINATION SWITCH ASSEMBLY

a.
A251305

Disengage the 4 claws and remove the combination switch assembly.