Home › Engine / Hybrid System › 2ZR-FXE (ENGINE MECHANICAL) › FRONT CRANKSHAFT OIL SEAL › 2012.03–2013.08
RM2070E _51 Engine / Hybrid System _061907 2ZR-FXE ENGINE MECHANICAL _0301596 FRONT CRANKSHAFT OIL SEAL A

2ZR-FXE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11302A 1.INSTALL TIMING CHAIN COVER OIL SEAL

a.

Apply MP grease to the lip of a new oil seal.

NOTICE:

Keep the lip free from foreign matter.



b.
A215985E01
0.883,0.624 1.183,0.782 0.300,0.158 10 SST 1.233,0.711 1.554,0.711 1.554,0.711 1.554,1.846 false

Using SST and a hammer, tap in the oil seal until its surface is flush with the front oil seal retainer edge.

SST
09223-22010  

NOTICE:
·

Wipe off extra grease from the crankshaft.

·

Do not tap the oil seal at an angle.




Hide 13471 2.INSTALL CRANKSHAFT PULLEY

a.

Align the pulley set key with the key groove of the pulley.


b.
A213054E04
1.615,2.604 1.271,3.25 1.271,3.25 1.854,2.802 false 2.146,3.323 2.302,3.323 false 0.896,3.167 1.188,3.333 0.292,0.167 10 false SST 2.333,3.24 2.531,3.406 0.198,0.167 10 false *a 0.229,2.656 0.396,2.802 0.167,0.146 10 false *b

Using SST, hold the pulley in place and tighten the bolt.

Text in Illustration
*a Hold
*b Turn

SST
09213-58014  (91551-80840)
09330-00021  

Torque:
190 N*m (1937 kgf*cm, 140 ft.*lbf)


Hide 51107A 3.INSTALL REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH

Hide 4.INSPECT FOR OIL LEAK

Hide 51443C 5.INSTALL REAR ENGINE UNDER COVER RH

Hide 6.INSTALL FRONT WHEEL RH

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)