Home › Engine / Hybrid System › 2ZR-FXE (ENGINE MECHANICAL) › REAR CRANKSHAFT OIL SEAL › 2012.10–2014.11
RM2070E _51 Engine / Hybrid System _061907 2ZR-FXE ENGINE MECHANICAL _0301597 REAR CRANKSHAFT OIL SEAL A

2ZR-FXE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 30900 1.REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY

a.

Remove the hybrid vehicle transaxle assembly (See page Drivetrain>P410 (HYBRID TRANSMISSION / TRANSAXLE)>HYBRID VEHICLE TRANSAXLE>REMOVAL).

NOTICE:

Be careful not to apply excess force to the transmission input damper assembly when removing or installing the hybrid vehicle transaxle assembly. If excess force is applied, the transmission input damper assembly may be damaged, or its splines may become misaligned.



Hide 31270 2.REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY

a.
A215986E01
0.801,2.989 1.094,3.147 0.294,0.158 10 SST 1.854,2.746 1.191,3.058 1.191,3.058 1.537,2.577 false

Using SST, hold the crankshaft damper.

SST
09213-58014  (91551-80840)
09330-00021  


b.
A213055

Remove the 6 bolts and transmission input damper assembly from the flywheel sub-assembly.


Hide 13405 3.REMOVE FLYWHEEL SUB-ASSEMBLY

a.
A215986E01
0.801,2.989 1.094,3.147 0.294,0.158 10 SST 1.854,2.746 1.191,3.058 1.191,3.058 1.537,2.577 false

Using SST, hold the crankshaft damper.

SST
09213-58014  (91551-80840)
09330-00021  


b.
A215742

Remove the 8 bolts and the flywheel.


Hide 11401L 4.REMOVE REAR ENGINE OIL SEAL

a.
A154925E15
0.823,1.375 0.885,1.813 0.885,1.813 0.948,1.813 false 2.073,1.344 2.844,0.917 2.844,0.917 2.979,0.917 true 0.969,1.729 1.156,1.917 0.188,0.188 10 false *a 3.021,0.833 3.208,1.021 0.188,0.188 10 false *1

Using a knife, cut off the lip of the oil seal.

Text in Illustration
*1 Protective Tape
*a Cut Position


b.

Using a screwdriver with its tip wrapped with tape, pry out the oil seal.

NOTICE:

After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.