13711
1.REMOVE INTAKE VALVE
Type A and Type B can be distinguished by the shape of the compression spring.
| *A | Type A |
| *B | Type B |
| *1 | No. 1 Valve Rocker Arm Sub-assembly |
| *2 | Valve Spring Retainer |
| *3 | Compression Spring |
| *4 | Valve Lash Adjuster Assembly |
| Type | Compression Spring Shape |
|---|---|
| A | Straight |
| B | Tapered |
Type A:
Place the cylinder head on wooden blocks.
Using SST and wooden blocks, compress and remove the 8 valve retainer locks.
Arrange the removed parts in the correct order.
Remove the 8 retainers, 8 valve springs and 8 valves.
Arrange the removed parts in the correct order.
Type B:
Place the cylinder head on wooden blocks.
Using SST and wooden blocks, compress and remove the valve retainer locks.
Arrange the removed parts in the correct order.
Remove the retainer, valve spring and valve.
Arrange the removed parts in the correct order.
13715
2.REMOVE EXHAUST VALVE
Type A and Type B can be distinguished by the shape of the compression spring.
| *A | Type A |
| *B | Type B |
| *1 | No. 1 Valve Rocker Arm Sub-assembly |
| *2 | Valve Spring Retainer |
| *3 | Compression Spring |
| *4 | Valve Lash Adjuster Assembly |
| Type | Compression Spring Shape |
|---|---|
| A | Straight |
| B | Tapered |
Type A:
Place the cylinder head on wooden blocks.
Using SST and wooden blocks, compress and remove the 8 valve retainer locks.
Arrange the removed parts in the correct order.
Remove the 8 retainers, 8 valve springs and 8 valves.
Arrange the removed parts in the correct order.
Type B:
Place the cylinder head on wooden blocks.
Using SST and wooden blocks, compress and remove the valve retainer locks.
Arrange the removed parts in the correct order.
Remove the retainer, valve spring and valve.
Arrange the removed parts in the correct order.
3.REMOVE VALVE STEM OIL SEAL
Using needle-nose pliers, remove the 16 oil seals.
13734
4.REMOVE VALVE SPRING SEAT
Using compressed air and a Magnet Hand, remove the 16 valve spring seats by blowing air onto them.
11117B
5.REMOVE NO. 2 STRAIGHT SCREW PLUG
If water leaks from the straight screw plug or the plug is corroded, replace it.
Using a 10 mm straight hexagon wrench, remove the 3 screw plugs and 3 gaskets.
6.REMOVE STUD BOLT
If a stud bolt is deformed or its threads are damaged, replace it.