Home › Engine / Hybrid System › 2ZR-FXE (FUEL) › FUEL INJECTOR › 2012.03–2013.08
RM2070E _51 Engine / Hybrid System _061908 2ZR-FXE FUEL _0301603 FUEL INJECTOR A

2ZR-FXE FUEL  FUEL INJECTOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2. DISCHARGE FUEL SYSTEM PRESSURE

Hide 8.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 25601L 9.REMOVE EGR WITH COOLER PIPE SUB-ASSEMBLY

Hide 82121 10.DISCONNECT ENGINE WIRE

A216398

a.

Disconnect the 4 fuel injector connectors.


b.

Disconnect the 4 connectors.


c.

Remove the bolt.


d.

Disconnect the 2 clamps to disconnect the engine wire.


Hide 23901 11.DISCONNECT FUEL TUBE SUB-ASSEMBLY

a.
A216403

Release the claw and remove the No. 1 fuel pipe clamp.


b.
U110522

Pinch the fuel tube connector, and then pull the fuel tube connector off of the fuel pipe.

NOTICE:
·

Check for foreign matter in the fuel tube around the fuel tube connector. Clean it if necessary. Foreign matter can affect the ability of the O-ring to seal the fuel tube connector and fuel pipe.

·

Do not use any tools to separate the fuel tube connector and fuel pipe.

·

Do not forcefully bend, kink or twist the hose.

·

Keep the fuel tube connector and fuel pipe free from foreign matter.

·

If the fuel tube connector and fuel pipe are stuck together, pinch the fuel tube connector and turn it carefully to disconnect it.

·

Put the fuel tube connector in a plastic bag to prevent damage and contamination.




Hide 23807 12.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

a.
A216399

Remove the bolt.


b.
A216400

Remove the 2 bolts and fuel delivery pipe sub-assembly.

NOTICE:

Be careful not to drop the fuel injectors when removing the fuel delivery pipe.



Hide 23807V 13.REMOVE NO. 1 DELIVERY PIPE SPACER

a.
A216401

Remove the 2 delivery pipe spacers from the cylinder head.


Hide 23250 14.REMOVE FUEL INJECTOR ASSEMBLY

a.
A153009

Pull the 4 fuel injector assemblies out of the fuel delivery pipe sub-assembly.


b.

Remove the O-ring from each fuel injector assembly.


c.

For reinstallation, attach a tag or label to each injector shaft.

NOTICE:

Prevent entry of foreign matter by covering the fuel injectors with plastic bags.



d.
A216402

Remove the 4 injector vibration insulators.