83320
1.REMOVE FUEL SENDER GAUGE ASSEMBLY
23220A
2.REMOVE FUEL PUMP WITH FILTER ASSEMBLY
Disconnect the connector of the fuel pump harness.
Disconnect the fuel pump filter hose.
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws, and remove the fuel filter and fuel pump from the fuel sub-tank.
| *1 | Fuel Tube |
| *2 | Fuel Sub-tank |
Do not do anything which may separate the fuel tube from either the fuel suction plate or fuel filter assembly, such as applying excessive force to the tube (See page Engine / Hybrid System>2ZR-FXE (FUEL)>FUEL SYSTEM>PRECAUTION).
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the No. 1 fuel suction support.
Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws, and remove the fuel pump from the fuel filter.
| *1 | Fuel Filter |
| *2 | Suction Filter |
Do not damage the fuel filter.
Do not remove the suction filter.
Do not use either the fuel pump or the suction filter if the suction filter is removed from the fuel pump.
Disconnect the fuel pump harness connector.
Remove the O-ring and spacer from the fuel pump with filter assembly.
| *1 | O-ring |
| *2 | Spacer |
| *a | 5.0 mm (0.197 in.) |
Be careful not to damage the sealing surface.
If the O-ring still remains in the fuel filter, remove it using a wire tip (1 mm diameter) that is formed as shown in the illustration.