Home › Engine / Hybrid System › 2ZR-FXE (EMISSION CONTROL) › EMISSION CONTROL SYSTEM › from 2016.05
RM2070E _51 Engine / Hybrid System _061909 2ZR-FXE EMISSION CONTROL _0301608 EMISSION CONTROL SYSTEM G

2ZR-FXE EMISSION CONTROL  EMISSION CONTROL SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS

a.

Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.

NOTICE:
·

Detachment or other problems with the engine oil dipstick, filler cap, ventilation hose and other components may cause the engine to run improperly.

·

Air suction caused by disconnections, looseness or cracks in any part of the air induction system between the throttle body and cylinder head will cause an engine failure or engine malfunction.



If any defects are found, replace parts as necessary.


Hide 2.INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM

a.

Connect the GTS to the DLC3.


b.
A215617

Disconnect the fuel vapor feed hose from the purge valve shown in the illustration.


c.

Put the engine in inspection mode (See page General>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE).


d.

Start the engine.


e.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for Evap Control.


f.

Check that vacuum occurs at the purge valve port.


g.

If vacuum does not occur, check the following items.

HINT:
·

Purge VSV (for canister purge)

·

Clogging in the fuel vapor feed hose connecting the intake manifold and Purge VSV

·



h.

Exit Active Test mode and reconnect the fuel vapor feed hose.


i.

Enter the following menus: Powertrain / Engine and ECT / Data List / EVAP Purge VSV.


j.

Warm up the engine and drive the vehicle.


k.

Confirm that the purge valve opens.

If the result is not as specified, replace the purge valve, wire harness or ECM.