Home › Engine / Hybrid System › 2ZR-FXE (EMISSION CONTROL) › EGR VALVE
RM2070E _51 Engine / Hybrid System _061909 2ZR-FXE EMISSION CONTROL _0301609 EGR VALVE G

2ZR-FXE EMISSION CONTROL  EGR VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.PERFORM ACTIVE TEST USING GTS (CONTROL THE EGR STEP POSITION)

a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Put the engine in inspection mode (maintenance mode) (See pageGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE ).


e.

Start the engine and warm it up until the engine coolant temperature reaches 75°C (167°F) or higher.

HINT:

The A/C switch and all accessory switches should be off and park (P) or neutral (N) selected.



f.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the EGR Step Position / All Data / MAP.


g.

Check the MAP value in the Data List while performing the Active Test.

HINT:
·

Do not leave the EGR valve open for 10 seconds or more during the Active Test.

·

Be sure to return the EGR valve to step 0 when the Active Test is completed.

·

Do not open the EGR valve 30 steps or more during the Active Test.



OK:

MAP change in response to EGR step position.


Standard:
- EGR Step Position (Active Test)
0 Steps 0 to 30 Steps
MAP
(Data List)
(EGR valve is fully closed) MAP value is at least +10 kPa (75 mmHg) higher than when EGR valve is fully closed


HINT:
·

While performing the Active Test, if the increase in the value of MAP is small, the EGR valve assembly may be a malfunctioning.

·

Even if the EGR valve assembly is malfunctioning, rough idling or an increase in the value of MAP may occur while performing the Active Test. However, the amount that the value of MAP increases will be smaller than normal.