Home › Engine / Hybrid System › 2ZR-FXE (EMISSION CONTROL) › PURGE VALVE
RM2070E _51 Engine / Hybrid System _061909 2ZR-FXE EMISSION CONTROL _0301613 PURGE VALVE G

2ZR-FXE EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 17650 1.INSPECT PURGE VSV

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω


If the result is not as specified, replace the purge VSV.


b.
U110607E03
1.094,1.708 0.604,1.708 false 1.271,1.052 0.74,1.052 false 0.604,1 0.729,1.146 0.125,0.146 10 false E 0.469,1.635 0.594,1.781 0.125,0.146 10 false F 1.031,0.073 1.198,0.229 0.167,0.156 10 false *a

Apply auxiliary battery voltage between the terminals of the purge VSV and check that the following occurs when blowing air into port E.

OK:
Measurement Condition Specified Condition
Auxiliary battery voltage applied between terminals 1 and 2 Air flows from port F
Auxiliary battery voltage not applied between terminals 1 and 2 Air does not flow


Text in Illustration
*a Air

If the result is not as specified, replace the purge VSV.