Home › Engine / Hybrid System › 2ZR-FXE (COOLING) › COOLING SYSTEM › from 2014.11
RM2070E _51 Engine / Hybrid System _061911 2ZR-FXE COOLING _0301620 COOLING SYSTEM G

2ZR-FXE COOLING  COOLING SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FOR COOLANT LEAK (for Engine)

CAUTION:

Do not remove the reserve tank cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


NOTICE:

Before performing each inspection, turn the A/C switch off.


a.

Remove the reserve tank cap.


b.
A213419

Fill the reserve tank with coolant, and then attach a radiator cap tester.


c.

Put the engine in inspection mode (See page General>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE).


d.

Warm up the engine.


e.

Using a radiator cap tester, increase the pressure inside the radiator to 108 kPa (1.1 kgf/cm2, 16 psi), and check that the pressure does not drop. If the pressure drops, check the hoses, radiator, front exhaust pipe assembly, the heater hose around the engine coolant temperature sensor and engine water pump assembly for leaks. If no external leaks are found, check the heater core, cylinder block and cylinder head.


f.

Remove the radiator cap tester.


g.

Install the reserve tank cap.


Hide 2.INSPECT RESERVOIR TANK ENGINE COOLANT LEVEL (for Engine)

a.
A213418E12
1.5,0.99 2.135,1.802 2.135,1.802 2.198,1.802 false 1.5,0.823 2.094,1.5 2.094,1.5 2.156,1.5 false 2.198,1.427 2.354,1.573 0.156,0.146 10 false *1 2.229,1.729 2.385,1.875 0.156,0.146 10 false *2

Check that the engine coolant level is between the low and full lines when the engine is cold.

Text in Illustration
*1 Full Line
*2 Low Line

HINT:

If the engine coolant level is low, check for leaks and add "TOYOTA Super Long Life Coolant" or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite and non-borate coolant with long-life hybrid organic acid technology to the full line.



Hide 3.INSPECT ENGINE COOLANT QUALITY (for Engine)

a.

Remove the reserve tank cap.

CAUTION:

Do not remove the reserve tank cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



b.

Check if there are any excessive deposits of rust or scales around the reserve tank cap and reserve tank filler hole. Also, the coolant should be free of oil.

If excessively dirty, clean the coolant passage and replace the coolant.


c.

Install the reserve tank cap.