Home › Engine / Hybrid System › 2ZR-FXE (COOLING) › THERMOSTAT
RM2070E _51 Engine / Hybrid System _061911 2ZR-FXE COOLING _0301626 THERMOSTAT G

2ZR-FXE COOLING  THERMOSTAT  INSPECTION  


PROCEDURE

Hide 16031 1.INSPECT WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

a.
A216465

Immerse the water inlet with thermostat sub-assembly in water and then gradually heat the water.


b.

Check the valve opening temperature of the water inlet with thermostat sub-assembly.

Valve opening temperature:

80 to 84°C (176 to 183°F)


HINT:

If the valve opening temperature is not as specified, replace the water inlet with thermostat sub-assembly.



c.
A380349E03
1.479,0.729 1.646,0.333 1.646,0.333 1.75,0.333 false 1.479,2.969 1.646,2.573 1.646,2.573 1.75,2.573 false 1.167,1.74 1.375,1.979 0.208,0.24 10 false *a 1.792,0.24 2,0.479 0.208,0.24 10 false *b 0.083,2.25 0.302,2.49 0.219,0.24 12 false *B 0.094,0.063 0.313,0.302 0.219,0.24 12 false *A 1.188,3.958 1.396,4.198 0.208,0.24 10 false *a 1.781,2.49 1.99,2.729 0.208,0.24 10 false *b

Check the valve lift.

Text in Illustration
*A Compression Spring Shape: Tapered
*B Compression Spring Shape: Straight
*a Valve Lift
*b Compression Spring

Standard Valve Lift:
Compression Spring Shape Condition Specified Condition
Tapered 95°C (203°F) 10 to 14 mm (0.394 to 0.551 in.)
Straight 8 mm (0.315 in.) or more


HINT:

If the valve lift is not as specified, replace the water inlet with thermostat sub-assembly.



d.

Check that the valve is fully closed when the water inlet with thermostat sub-assembly is at low temperatures (below 77°C (171°F)).

HINT:

If it is not fully closed, replace the water inlet with thermostat sub-assembly.