Home › Engine / Hybrid System › 2ZR-FXE (COOLING) › RADIATOR
RM2070E _51 Engine / Hybrid System _061911 2ZR-FXE COOLING _0301629 RADIATOR G

2ZR-FXE COOLING  RADIATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16475A 1.CHECK RESERVE TANK CAP (for Engine)

a.
A112200

Measure the valve opening pressure.

i.

If there are water stains or foreign matter on O-ring 1, clean it with water and finger scouring.


ii.

Check that O-ring 1 is not deformed, cracked or swollen.


iii.

Apply engine coolant to O-ring 1 and rubber packing 2 before using a radiator cap tester.


iv.

When using the cap tester, tilt it upwards 30 degrees or more.


v.
B008802E24
2.052,0.208 1.927,0.208 1.927,0.208 1.688,0.448 false 0.875,0.281 0.75,0.281 0.75,0.281 0.51,0.531 false 0.51,0.927 0.677,1.146 0.167,0.219 10 false *a 2.073,0.135 2.26,0.302 0.188,0.167 10 false *1 0.896,0.198 1.104,0.344 0.208,0.146 10 false *2

Pump the cap tester several times, and check the maximum pressure*1.

Text in Illustration
*1 Radiator Cap Tester
*2 Reserve tank Cap
*a 30° or more

Pumping speed:

1 pump per second


HINT:

*1: Even if the cap cannot maintain the maximum pressure, it is not a defect.


Judgment Criterion:
Item Specified Condition
Standard value
(for brand-new cap)
94 to 122 kPa (1.0 to 1.2 kgf/cm2, 13.5 to 17 psi)
Minimum standard value
(for used cap)
79 kPa (0.8 kgf/cm2, 11.4 psi)


If the maximum pressure is less than the minimum standard value, replace the reserve tank cap.