Home › Engine / Hybrid System › 2ZR-FXE (LUBRICATION) › OIL PUMP
RM2070E _51 Engine / Hybrid System _061912 2ZR-FXE LUBRICATION _0301631 OIL PUMP G

2ZR-FXE LUBRICATION  OIL PUMP  INSPECTION  


PROCEDURE

Hide 15131 1.INSPECT OIL PUMP RELIEF VALVE

a.
A216971

Coat the oil pump relief valve with engine oil, then check that it falls smoothly into the valve hole by its own weight.

If this does not occur, repair or replace the oil pump assembly.


Hide 2.INSPECT OIL PUMP ROTOR

a.
A150989

Using a feeler gauge, measure the clearance between the drive and driven rotor tips.

Standard tip clearance:

0.08 to 0.16 mm (0.00315 to 0.00631 in.)


Maximum tip clearance:

0.35 mm (0.0138 in.)


If the tip clearance is greater than the maximum, replace the oil pump assembly.


b.
A150987

Using a feeler gauge and precision straightedge, measure the clearance between the 2 rotors and precision straightedge.

Standard side clearance:

0.085 to 0.135 mm (0.00335 to 0.00532 in.)


Maximum side clearance:

0.16 mm (0.00631 in.)


If the side clearance is greater than the maximum, replace the oil pump assembly.


c.
A150988

Using a feeler gauge, measure the clearance between the driven rotor and oil pump body.

Standard body clearance:

0.12 to 0.19 mm (0.00472 to 0.00750 in.)


Maximum body clearance:

0.325 mm (0.0128 in.)


If the body clearance is greater than the maximum, replace the oil pump assembly.