1.INSPECT POWER SWITCH
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| L43-7 (SS1) - L43-5 (GND) | Pushed | Below 1 Ω |
| L43-2 (SS2) - L43-5 (GND) | Pushed | Below 1 Ω |
| L43-7 (SS1) - L43-5 (GND) | Not pushed | 10 kΩ or higher |
| L43-2 (SS2) - L43-5 (GND) | Not pushed | 10 kΩ or higher |
If the result is not as specified, replace the power switch.
Apply auxiliary battery voltage between the terminals of the switch, and check the illumination condition of the power switch.
| *a | Indicator Light | *b | Power Switch Illumination |
| Measurement Condition | Specified Condition |
|---|---|
| Auxiliary battery positive (+) →Terminal L43-11 (SWIL)
Auxiliary battery negative (-) →Terminal L43-4 (COM) or L43-5 (GND) |
Illuminates
(Power Switch Illumination) |
| Auxiliary battery positive (+) →Terminal L43-12 (INDS)
Auxiliary battery negative (-) →Terminal L43-4 (COM) or L43-5 (GND) |
Illuminates
(Indicator Light) |
| Auxiliary battery positive (+) →Terminal L43-13 (INDW)
Auxiliary battery negative (-) →Terminal L43-4 (COM) or L43-5 (GND) |
Illuminates
(Indicator Light) |
If the result is not as specified, replace the power switch.