Home › Engine / Hybrid System › 2ZR-FXE (STARTING) › POWER SWITCH › from 2016.05
RM2070E _51 Engine / Hybrid System _061913 2ZR-FXE STARTING _0301635 POWER SWITCH G

2ZR-FXE STARTING  POWER SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT POWER SWITCH

a.
A295732E11
1.229,1.052 0.781,0.594 0.781,0.594 0.604,0.594 false 2.198,1.083 2.625,0.76 2.625,0.76 2.719,0.76 false 2.198,1.406 2.625,1.698 2.625,1.698 2.802,1.698 false 1.479,1.417 1.24,1.844 1.24,1.844 1.063,1.844 false 0.052,0.021 0.26,0.208 0.208,0.188 10 false *a 0.302,0.521 0.615,0.688 0.313,0.167 10 false SS1 2.813,0.667 3.125,0.833 0.313,0.167 10 false SS2 2.865,1.594 3.323,1.76 0.458,0.167 10 false AGND 0.635,1.781 1.01,1.948 0.375,0.167 10 false SWIL

Measure the resistance according to the value(s) in the table below.

Text in Illustration
*a Component without harness connected
(Power Switch)

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 (SS1) - 6 (AGND)
1 (SS2) - 6 (AGND)
Not pushed 10 kΩ or higher
Pushed Below 1 Ω


If the result is not as specified, replace the power switch.


b.

Apply auxiliary battery voltage between the terminals of the power switch, and check the illumination condition of the power switch indicator light.

OK:
Condition Specified Condition
Auxiliary battery positive (+) → Terminal 9 (SWIL)
Auxiliary battery negative (-) → Terminal 6 (AGND)
Illuminates


HINT:
·

If the positive (+) lead and the negative (-) lead are incorrectly connected, the power switch indicator light will not illuminate.

·

If the voltage is too low, the power switch indicator light will not illuminate.



If the result is not as specified, replace the power switch.