Home › Engine / Hybrid System › 2ZR-FXE (STARTING) › POWER SWITCH › 2013.08–2014.11
RM2070E _51 Engine / Hybrid System _061913 2ZR-FXE STARTING _0301635 POWER SWITCH A

2ZR-FXE STARTING  POWER SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 9.REMOVE POWER SWITCH

a.
A251303

Disengage the 2 claws and remove the power switch.