The vehicle speed sensors send vehicle speed signals to the brake booster with master cylinder (skid control ECU). Signals are then sent to the hybrid vehicle control ECU.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0122 | While power switch is on (IG), communication stop between brake booster with master cylinder (skid control ECU) and hybrid vehicle control ECU continues for 2.6 seconds or more | ·
Brake booster with master cylinder (skid control ECU) ·
CAN communication system ·
Hybrid vehicle control ECU |
Connect the GTS to the DLC3.
Select "Bus Check" from the "System Select".
Select "DTC" from the "Bus Check" screen, and then select "Enter".
| Result | Proceed to |
|---|---|
| CAN communication system DTC is not output | A |
| CAN communication system DTC is output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B