Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › 2012.03–2013.08
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301639 CRUISE CONTROL SYSTEM C

CRUISE CONTROL  CRUISE CONTROL SYSTEM  P0575  Cruise Control Input Circuit  


DESCRIPTION

This DTC indicates an abnormality in the power management control ECU.

DTC No. DTC Detection Condition Trouble Area
P0575 When both of the following conditions are met:
·

STP signals input to the power management control ECU supervisory CPU and control ECU are different for 0.15 seconds or more

·

0.4 seconds have passed after cruise cancel input signal (STP input) is input to the power management control ECU


Power management control ECU

HINT:

The power management control ECU receives signals from each sensor to control all functions of the cruise control system. When a trouble code is detected, the fail-safe function activates and remains on until the power switch is turned off.


PROCEDURE

1.CHECK FOR DTCs (DTC P0575)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.



e.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive at a speed of between approximately 40 km/h (25 mph) and 200 km/h (125 mph).


ii.

Turn the cruise control system on using the ON-OFF switch.


iii.

Push the -/SET switch to activate the cruise control.



f.

Enter the following menus: Powertrain / Cruise Control / Trouble Codes.


g.

Check for DTCs.

Result:
Result Proceed to
DTC is not output A
DTC P0575 is output B




A

B