These DTCs are stored when a communication malfunction occurs between the sensors and ECUs.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0122 | While dynamic radar cruise control is either preparing for operation or operating and power switch is on (IG), communication stop between skid control ECU and driving support ECU assembly continues for 1 second or more | ·
Brake booster with master cylinder (skid control ECU) ·
Hybrid vehicle control ECU ·
Driving support ECU assembly ·
CAN communication system |
| U0123 | While dynamic radar cruise control is either preparing for operation or operating and power switch is on (IG), communication stop between yaw rate sensor (airbag ECU assembly) and driving support ECU assembly continues for 1 second or more | ·
Yaw rate sensor (airbag ECU assembly) ·
Hybrid vehicle control ECU ·
Driving support ECU assembly ·
CAN communication system |
| U0126 | While dynamic radar cruise control is either preparing for operation or operating and power switch is on (IG), communication stop between steering angle sensor and driving support ECU assembly continues for 1 second or more | ·
Steering angle sensor ·
Hybrid vehicle control ECU ·
Driving support ECU assembly ·
CAN communication system |
| U0293 | While dynamic radar cruise control is either preparing for operation or operating and power switch is on (IG), communication stop between hybrid vehicle control ECU and driving support ECU assembly or skid control ECU continues for 1 second or more | ·
Hybrid vehicle control ECU ·
Driving support ECU assembly ·
Brake booster with master cylinder (skid control ECU) ·
CAN communication system |
| U1104 | While dynamic radar cruise control is either preparing for operation or operating and power switch is on (IG), communication stop between driving support ECU assembly and millimeter wave radar sensor assembly, hybrid vehicle control ECU, or brake booster with master cylinder (skid control ECU) continues for 1 second or more | ·
Driving support ECU assembly ·
Hybrid vehicle control ECU ·
Millimeter wave radar sensor assembly ·
Brake booster with master cylinder (skid control ECU) ·
Wire harness or connector (Driving support ECU assembly - millimeter wave radar sensor assembly) ·
CAN communication system |
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the tester on.
Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Check for DTCs.
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output | A |
| CAN communication system DTCs are output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B