When the driving support ECU is replaced with a new one, it acquires the country specification information (destination, steering wheel position, etc.) from the main body ECU. When the country specification information in the driving support ECU assembly and main body ECU do not match, DTC C1A02 is output.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1A02 | While power switch is on (IG) and dynamic radar cruise control system is operating, driving support ECU assembly does not receive vehicle destination information | Driving support ECU assembly |
Select the "CAN Bus Check" from the "System Selection Menu" screen on the GTS.
Select "Communication Malfunction DTC" from the "CAN Bus Check" screen, and then select "Enter".
CAN communication system DTC is not output.
OK
NG
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Clear the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
Perform the following to make sure that the DTC detection conditions are met.
If the detection conditions are not met, the malfunction cannot be detected.
Drive the vehicle at a speed of between approximately 50 km/h (30 mph) and 170 km/h (105 mph).
Turn the cruise control system on using the cruise control switch (ON-OFF button).
Push the cruise control switch to -/SET to begin control of vehicle speed using the cruise control system.
Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC C1A02 is output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B