Home › Engine / Hybrid System › CRUISE CONTROL › LANE RECOGNITION CAMERA SENSOR › 2014.11–2017.12
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301641 LANE RECOGNITION CAMERA SENSOR A

CRUISE CONTROL  LANE RECOGNITION CAMERA SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

When replacing the windshield glass of a vehicle equipped with a lane departure warning camera, make sure to use a Toyota genuine part. If a non-Toyota genuine part is used, the lane departure warning camera may not be able to be installed due to a missing bracket or the lane departure alert system may not operate properly due to a difference in the transmissivity or black ceramic border.


PROCEDURE

Hide 86466B 1.REMOVE NO. 2 LANE RECOGNITION COVER

a.

Disengage the 2 guides and remove the No. 2 lane recognition cover as shown in the illustration.

E306533E01
0.489,2.751 6.695,4.503 6.206,1.752


Hide 86466A 2.REMOVE NO. 1 LANE RECOGNITION COVER

a.
E306599

Disengage the 4 guides and remove the No. 1 lane recognition cover as shown in the illustration.


Hide 86468 3.REMOVE LANE DEPARTURE WARNING CAMERA

a.
E306538E01
2.695,3.631 2.907,3.843 0.212,0.212 10 1 1.493,3.864 1.681,4.076 0.188,0.212 10 2

Disconnect the connector.


b.

Disengage the 3 guides and remove the lane departure warning camera as indicated by the arrows, in the order shown in the illustration.

NOTICE:
·

Do not pull the harness forcibly when disconnecting the connector.

·

If the lane departure warning camera bracket is deformed or damaged, replace it together with the windshield glass.

·

If the lane departure warning camera is dropped, replace it with a new one.