Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SWITCH › from 2014.11
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301642 LANE DEPARTURE ALERT SWITCH G

CRUISE CONTROL  LANE DEPARTURE ALERT SWITCH  INSPECTION  


PROCEDURE

Hide 84010D 1.INSPECT LANE DEPARTURE ALERT MAIN SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY)

a.
B388839E02
0.256,0.098 0.628,0.337 0.371,0.239 10 *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 - 5 Lane departure alert main switch on Below 1 Ω
2 - 5 Lane departure alert main switch off 10 kΩ or higher


Text in Illustration
*a Component without harness connected
(Lane Departure Alert Main Switch))


b.

Check that the switch illuminates.

i.

Apply auxiliary battery voltage to the lane departure alert main switch connector and check that the lane departure alert main switch illuminates.

OK:
Connection Specified Condition
Auxiliary battery positive (+) → Terminal 4
Auxiliary battery negative (-) → Terminal 1
Illuminates