Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM › 2014.11–2017.12
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301643 LANE DEPARTURE ALERT SYSTEM J

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the lane departure warning camera.

WIRING DIAGRAM

E240004E23
0.385,0.698 1.365,1.146 0.979,0.448 10 false from IG1 NO. 1 Relay 2.792,0.854 3.844,1.083 1.052,0.229 10 false ECU-IG NO. 2 5,0.698 5.479,0.979 0.479,0.281 10 false IGB 4.99,1.604 5.448,1.823 0.458,0.219 10 false GND 4.771,0.594 4.938,0.74 0.167,0.146 10 false 7 4.74,1.479 4.927,1.625 0.188,0.146 10 false 11 4.469,2.104 4.823,2.323 0.354,0.219 10 false U13 4.479,2.271 6.771,2.646 2.292,0.375 10 false Lane Departure Warning Camera

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK TERMINAL VOLTAGE (POWER SOURCE OF LANE DEPARTURE WARNING CAMERA)
a.

Disconnect the U13 lane departure warning camera connector.


U191398E02
1.292,1.396 1.198,1.76 false 1.958,1.417 2.073,1.781 false 1.594,0.208 2.01,0.354 0.417,0.146 10 false U13 1.021,1.781 1.333,2 0.313,0.219 10 false IGB 1.948,1.802 2.333,2.021 0.385,0.219 10 false GND 0.146,0.073 0.344,0.271 0.198,0.198 10 false *a

b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
U13-7 (IGB) - Body ground Power switch on (IG) 11 to 14 V
U13-7 (IGB) - Body ground Power switch off Below 1 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
U13-11 (GND) - Body ground Always Below 1 Ω


Text in Illustration
*a Front view of wire harness connector
(to Lane Departure Warning Camera)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR