Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM › 2014.11–2017.12
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301643 LANE DEPARTURE ALERT SYSTEM U

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  FAIL-SAFE CHART  


CONDITIONS FOR MOMENTARY STOP


a.
B392600E01
0.995,0.059 1.256,0.284 0.260,0.225 10 *a 0.342,1.356 0.602,1.582 0.260,0.225 10 *b

When control is stopped momentarily, "LANE DEPARTURE ALERT UNAVAILABLE CAMERA OVERHEATED" is displayed in the combination meter sub-assembly, the lane departure alert indicator turns off and a "pong" sound is heard. This occurs under the following condition:

Text in Illustration
*a Lane Departure Alert Indicator
*b Multi-information Display

·

A high lane departure warning camera temperature is detected.




HINT:

When the system recovers and the condition to stop lane departure alert control is not met, the lane departure alert system operates again.


STOP DUE TO SYSTEM MALFUNCTION


a.
B392601E01
1.07,0.028 1.396,0.296 0.326,0.268 10 *a 0.373,1.259 0.698,1.527 0.326,0.268 10 *b

When a system malfunction is detected, the lane departure alert indicator turns off, "LANE DEPARTURE ALERT MALFUNCTION VISIT YOUR DEALER" is displayed in the combination meter sub-assembly and a "pong" sound is heard.

Text in Illustration
*a Lane Departure Alert Indicator
*b Multi-information Display

HINT:

After the power switch is turned off then back on (IG), the lane departure alert system operates again if the system is confirmed to be normal when the lane departure alert main switch (integration control and panel assembly) is turned on.