These DTCs are output when a communication malfunction occurs between the sensors and ECUs.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0101 | While the vehicle is being driven at 1 km/h or 1 mph or more, communication between the power management control ECU and lane departure warning camera stops for 5 seconds or more. | ·
CAN communication system ·
Power management control ECU ·
Lane departure warning camera |
| U0123 | While the vehicle is being driven at 1 km/h or 1 mph or more, communication between the yaw rate sensor and lane departure warning camera stops for 5 seconds or more. | ·
CAN communication system ·
Yaw rate sensor) ·
Lane departure warning camera |
| U0129 | While the power switch is on (IG), communication between the brake booster with master cylinder assembly (skid control ECU) and lane departure warning camera stops for 5 seconds or more. | ·
CAN communication system ·
Skid control ECU (brake booster with master cylinder assembly) ·
Lane departure warning camera |
| U0142 | While the power switch is on (IG), communication between the main body ECU (multiplex network body ECU) and lane departure warning camera stops for 5 seconds or more. | ·
CAN communication system ·
Main body ECU (multiplex network body ECU) ·
Lane departure warning camera |
| U0155 | While the power switch is on (IG), communication between the combination meter sub-assembly and lane departure warning camera stops for 50 seconds or more. | ·
CAN communication system ·
Combination meter sub-assembly ·
Lane departure warning camera |
Clear the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR).
Check the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output | A |
| CAN communication system DTCs are output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B