Home › Drivetrain › P410 (HYBRID TRANSMISSION / TRANSAXLE) › SHIFT CONTROL ACTUATOR › from 2012.10
RM2070E _52 Drivetrain _061915 P410 HYBRID TRANSMISSION / TRANSAXLE _0301653 SHIFT CONTROL ACTUATOR A

P410 HYBRID TRANSMISSION / TRANSAXLE  SHIFT CONTROL ACTUATOR  REMOVAL  


PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 35580 4.REMOVE SHIFT CONTROL ACTUATOR ASSEMBLY

a.
C237396

Disconnect the 2 connectors.


b.

Remove the bolt and disconnect the wire harness clamp bracket.


c.
C264836

Remove the 3 shift control actuator bolts and shift control actuator assembly.

HINT:
·

Please refer to Service Bulletin for details on the removal procedure of the shift control actuator bolt.

·

This actuator is a precision instrument. Do not strike it with a plastic hammer or the like during installation.

·

This actuator detects its own position when a battery is reinstalled. Thus it does not require initialization.




Hide 35563 5.REMOVE SHIFT CONTROL ACTUATOR SEAL

NOTICE:

It is not always necessary to replace or remove/install the shift control actuator seal at the same time when replacing the shift control actuator assembly.


HINT:

Remove/install the shift control actuator seal only if oil leaks from the shift control actuator seal or other faults are found when the shift control actuator assembly is removed.


a.

Using a screwdriver with its tip taped, remove the shift control actuator seal.

NOTICE:

When removing the shift control actuator seal, be sure not to damage the case or manual shaft with the screwdriver.