Home › Drivetrain › P410 (HYBRID TRANSMISSION / TRANSAXLE) › HYBRID VEHICLE TRANSAXLE UNIT
RM2070E _52 Drivetrain _061915 P410 HYBRID TRANSMISSION / TRANSAXLE _0301655 HYBRID VEHICLE TRANSAXLE UNIT G

P410 HYBRID TRANSMISSION / TRANSAXLE  HYBRID VEHICLE TRANSAXLE UNIT  INSPECTION  


PROCEDURE

Hide 1.INSPECT INPUT SHAFT ASSEMBLY END PLAY

a.
C269194E01
2.602,1.46 3.009,1.46 false 3.038,1.379 3.371,1.550 0.332,0.171 10 SST

Using a SST and dial indicator, measure the input shaft assembly end play.

SST
09951-01600  

Standard end play:

0.10 to 0.20 mm (0.00394 to 0.00787 in.)


If the value is not as specified, replace the planetary sun gear snap ring with one of the correct thickness.


Hide 35760A 2.INSPECT NO. 1 REAR PLANETARY GEAR ASSEMBLY

a.
C269733

Using a feeler gauge, measure the clearance between the No. 1 rear planetary gear assembly and the pinion gear.

Standard clearance:

0.11 to 0.91 mm (0.00433 to 0.0358 in.)


If the value is not as specified, replace the No. 1 rear planetary gear assembly.