When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2. DISABLE BRAKE CONTROL
3.REMOVE REAR WHEEL
89516D
4.DISCONNECT SKID CONTROL SENSOR WIRE
5.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
42491
6.REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
42431
7.REMOVE REAR DISC
42450B
8.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
Remove the 4 bolts, rear axle hub and bearing assembly from the rear axle beam assembly.