Home › Suspension › FRONT SUSPENSION › FRONT LOWER BALL JOINT
RM2070E _53 Suspension _061919 FRONT SUSPENSION _0301669 FRONT LOWER BALL JOINT A

FRONT SUSPENSION  FRONT LOWER BALL JOINT  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT AXLE ASSEMBLY

Hide 43340A 2.REMOVE FRONT LOWER BALL JOINT ASSEMBLY

a.

Secure the front axle assembly in a vise using aluminum plates.

NOTICE:

When using a vise, do not overtighten it.



b.
C158342

Remove the cotter pin and nut.


c.
C156924E15
1.302,0.781 1.302,0.271 1.302,0.271 0.74,0.271 false 1.156,0.792 1.156,0.271 false 2.656,0.115 2.927,0.115 2.927,0.115 2.927,0.844 false 2.813,0.844 2.813,0.115 false 0.448,0.198 0.76,0.365 0.313,0.167 10 false SST 2.375,0.031 2.688,0.198 0.313,0.167 10 false SST 2.646,1.458 2.823,1.615 0.177,0.156 10 false *a

Install SST to the front lower ball joint assembly as shown in the illustration.

Text in Illustration
*a 1 mm

SST
09960-20010  (09961-02050, 09961-02050)

NOTICE:

Check that the clearance measurement between SST and the front axle assembly is 1 mm (0.0394 in.).



d.
U154849E01
0.208,2.066 0.502,2.209 0.294,0.144 10 SST 1.01,2.151 0.557,2.151 false 2.009,1.22 2.195,1.685 2.195,1.685 2.351,1.685 false 2.223,3.582 2.334,3.745 0.111,0.163 10 B 2.226,3.287 2.337,3.450 0.111,0.163 10 A 2.05,0.422 2.26,0.422 false 2.05,1.007 2.274,1.007 false 2.16,0.951 2.163,0.476 false 2.207,0.61 2.372,0.755 0.165,0.145 10 *a 2.269,0.235 2.428,0.380 0.159,0.145 10 *a 2.374,1.595 2.564,1.744 0.191,0.149 10 *b

Using SST, remove the front lower ball joint assembly from the front axle assembly as shown in the illustration.

Text in Illustration
*a Apply grease
*b Place wrench here

SST
09960-20010  (09961-02010, 09961-02050, 09961-02050)

CAUTION:

Apply grease to the threads and end of the SST bolt.


NOTICE:
·

Install SST so that A and B are parallel.

·

Be sure to place the wrench on the part indicated in the illustration.

·

Do not damage the front lower ball joint dust cover.