Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › 2013.08–2016.05
RM2070E _53 Suspension _061921 TIRE PRESSURE MONITORING _0301678 TIRE PRESSURE WARNING SYSTEM U

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  TERMINALS OF ECU  


CHECK TIRE PRESSURE WARNING ECU AND RECEIVER


a.
U191132E01
0.354,1.088 0.636,1.259 0.282,0.170 10 R41 0.144,0.088 0.353,0.274 0.209,0.186 10 *a

Disconnect the R41 tire pressure warning ECU and receiver connector and measure the voltage and resistance on the wire harness side.

Text in Illustration
*a Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
R41-1 (IG) - R41-12 (GND) LG - W-B IG power source Power switch on (IG) 10 to 16 V
R41-12 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω


b.

Connect the R41 tire pressure warning ECU and receiver connector.


c.

Measure the voltage and resistance according to the value(s) in the table below. If the result is not as specified, the ECU may be malfunctioning.

HINT:

Inspect the connectors from the back side while the connectors are connected.


U191218E01
0.115,0.09 0.442,0.337 0.327,0.247 10 *a 2.033,0.877 2.315,1.029 0.282,0.152 10 R41

Text in Illustration
*a Component with harness connected
(Tire Pressure Warning ECU and Receiver)
- -

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
R41-2 (SPD) - R41-12 (GND) V - W-B Vehicle speed signal Vehicle is running Pulse generation (see waveform 1)
R41-3 (TC) - R41-12 (GND) L - W-B TC terminal Terminal TC is not connected 11 to 14 V
R41-5 (IND) - R41-12 (GND) Y - W-B Tire pressure warning light output signal
·

Power switch on (IG)

·

Tire pressure warning light off


3.2 V or higher
·

Power switch on (IG)

·

Tire pressure warning light on


0.9 to 3.2 V
R41-7 (CLSW) - R41-12 (GND) Y - W-B Tire pressure warning reset switch signal
·

Power switch on (IG)

·

Tire pressure warning reset switch on


Below 1.5 V
·

Power switch on (IG)

·

Tire pressure warning reset switch off


8 to 15 V
R41-10 (SIL) - R41-12 (GND) P - W-B Diagnostic tester communication line Power switch on (IG) 11 to 14 V


d.
U110360E03
0.667,1.167 1.063,1.365 0.396,0.198 10 false *a

Using an oscilloscope, check waveform 1.

Text in Illustration
*a GND

Waveform 1:
Item Contents
Terminal R41-2 (SPD) - R41-12 (GND)
Tool setting 5 V/DIV., 20 ms./DIV.
Vehicle condition Driving at 20 km/h (12 mph)

HINT:

The wavelength becomes shorter as the vehicle speed increases.