Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2016.05
RM2070E _53 Suspension _061921 TIRE PRESSURE MONITORING _0301678 TIRE PRESSURE WARNING SYSTEM U

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  TERMINALS OF ECU  


CHECK TIRE PRESSURE WARNING ECU AND RECEIVER


a.
U191134E01
0.354,1.088 0.680,1.259 0.326,0.170 10 R42 0.144,0.088 0.353,0.274 0.209,0.186 10 *a

Disconnect the R42 tire pressure warning ECU and receiver connector and measure the voltage or resistance on the wire harness side.

Text in Illustration
*a Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
R42-1 (IG) - R42-12 (GND) LG - W-B IG power source Power switch on (IG) 10 to 16 V
R42-7 (+B) - R42-12 (GND) B - W-B Power supply (from auxiliary battery) Always 10 to 16 V
R42-12 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω


b.

Connect the R42 tire pressure warning ECU and receiver connector.


c.

Measure the voltage and resistance according to the value(s) in the table below. If the result is not as specified, the ECU may be malfunctioning.

HINT:

Inspect the connectors from the back side while the connectors are connected.


U191219E01
0.115,0.09 0.442,0.337 0.327,0.247 10 *a 2.027,0.877 2.351,1.029 0.324,0.152 10 R42

Text in Illustration
*a Component with harness connected
(Tire Pressure Warning ECU and Receiver)
- -

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
R42-3 (CLSW) - R42-12 (GND) Y - W-B Tire pressure warning reset switch
·

Power switch on (IG)

·

Tire pressure warning reset switch on


Below 1.5 V
·

Power switch on (IG)

·

Tire pressure warning reset switch off


8 to 15 V
R42-4 (RDA) - R42-12 (GND) GR - W-B Output signals Power switch on (IG) Pulse generation (see waveform 1)
R42-5 (PRG) - R42-12 (GND) P - W-B Input signals Power switch on (IG) Pulse generation (see waveform 1)


d.
C240058E05
2.854,1.208 3.094,1.417 0.24,0.208 10 false *b 0.094,0.094 0.302,0.313 0.208,0.219 10 false *a

Using an oscilloscope, check waveform 1.

Text in Illustration
*a Example
*b GND

Waveform 1:
Item Contents
Terminal R42-4 (RDA) - R42-12 (GND)
R42-5 (PRG) - R42-12 (GND)
Tool setting 5 V/DIV, 5 ms./DIV.
Vehicle condition Power switch on (IG)

HINT:

The waveform shown in the illustration is an example. If the tester displays a waveform that alternates between high and low, where high is a voltage that is between the IG power source voltage and a voltage 2.2 V lower than the IG power source voltage, and where low is a voltage of between 0 and 1.2 V, the ECU can be judged normal.