Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2016.05
RM2070E _53 Suspension _061921 TIRE PRESSURE MONITORING _0301678 TIRE PRESSURE WARNING SYSTEM J

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  ECU Power Source Circuit  


DESCRIPTION

The IG circuit is the power source for the tire pressure warning ECU and receiver.

WIRING DIAGRAM

C270968E57
4.698,1.76 5.156,2.115 0.458,0.354 10 false R42 4.688,1.938 6.396,2.469 1.708,0.531 10 false Tire Pressure Warning ECU and Receiver 5.031,0.615 5.25,0.875 0.219,0.26 10 false IG 5.031,1.156 5.406,1.365 0.375,0.208 10 false GND 4.833,0.51 4.979,0.76 0.146,0.25 10 false 1 4.771,1.042 4.958,1.26 0.188,0.219 10 false 12 3.146,0.813 4.385,1.063 1.24,0.25 10 false ECU-IG NO. 1 0.979,0.635 1.938,0.875 0.958,0.24 10 false from IG Circuit

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

·

It is necessary to perform initialization (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.



HINT:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU AND RECEIVER POWER SOURCE)
a.
U191136E02
1.24,1.219 0.833,1.708 0.833,1.708 0.833,1.823 false 2.198,1.375 2.625,1.281 2.625,1.281 2.74,1.281 false 0.385,1.146 0.719,1.313 0.333,0.167 10 false R42 0.146,0.104 0.354,0.292 0.208,0.188 10 false *a 0.771,1.844 0.99,2.042 0.219,0.198 10 false IG 2.792,1.198 3.135,1.365 0.344,0.167 10 false GND

Disconnect the R42 tire pressure warning ECU and receiver connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
R42-1 (IG) - Body ground Power switch on (IG) 10 to 16 V
Power switch off Below 1 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
R42-12 (GND) - Body ground Always Below 1 Ω



Text in Illustration
*a Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)


OK

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR