Speed signals are input into the tire pressure warning ECU and receiver from the combination meter assembly. At the same time, the acceleration sensor in the tire pressure warning valve and transmitter detects driving conditions, and sends signals to the tire pressure warning ECU and receiver. If the speed signal from the combination meter assembly stops and the acceleration sensor signal in the tire pressure warning valve and transmitter indicates that the vehicle is being driven, DTC C2174/74 is stored.
DTC C2191/91 is stored only during the test mode.
| DTC Code | Detection Condition | Trouble Area |
|---|---|---|
| C2174/74 | Vehicle speed signal malfunction | ·
Combination meter assembly ·
Vehicle speed signal circuit ·
Wire harness or connector ·
Tire pressure warning ECU and receiver ·
Tire pressure warning valve and transmitter |
| C2191/91 | Test mode procedure is performed | ·
Combination meter assembly ·
Vehicle speed signal circuit ·
Wire harness or connector ·
Tire pressure warning ECU and receiver ·
Tire pressure warning valve and transmitter |
When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.
It is necessary to perform initialization (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU and/or one of the valve and transmitters has been replaced.
When the speedometer is not moving, first troubleshoot the meter / gauge system (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).
Turn the power switch off.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Check that the values indicated on the GTS and on the combination meter are the same.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Vehicle Speed | Vehicle speed reading/
min.: 0 km/h (0 mph) max.: 255 km/h (158 mph) |
Actual vehicle speed | Speed indicated on the combination meter assembly |
Vehicle speed indicated on the GTS indicates the actual speed.
OK
NG
Perform a driving test.
Check for DTCs (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DTC CHECK / CLEAR).
The time required for DTC C2174/74 to be stored is 20 minutes.
| Result | Proceed to |
|---|---|
| DTC C2174/74 is not output | A |
| DTC C2174/74 is output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
Disconnect the R41 tire pressure warning ECU and receiver connector.
Disconnect the L70 junction connector.
| *a | Front view of wire harness connector
(to Junction Connector) |
- | - |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R41-2 (SPD) - L70-1 | Always | Below 1 Ω |
| R41-2 (SPD) or L70-1 - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R41-2 (SPD) - L70-3 | Always | Below 1 Ω |
| R41-2 (SPD) or L70-3 - Body ground | Always | 10 kΩ or higher |
OK
NG
Replace the tire pressure warning ECU and receiver (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING RECEIVER>REMOVAL).
NEXT
Perform registration (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION).
NEXT
Perform initialization (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION).
NEXT
Perform a driving test.
Check for DTCs (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DTC CHECK / CLEAR).
The time required for DTC C2174/74 to be stored is 20 minutes.
| Result | Proceed to |
|---|---|
| DTC C2174/74 is output | A |
| DTC C2174/74 is not output | B |
A
B