Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM › 2012.03–2012.10
RM2070E _53 Suspension _061922 TIRE / WHEEL _0301681 TIRE AND WHEEL SYSTEM G

TIRE / WHEEL  TIRE AND WHEEL SYSTEM  INSPECTION  


PROCEDURE

Hide 1.INSPECT TIRES

a.

Check the tires for wear and proper inflation pressure.

Cold Tire Inflation Pressure:
Tire Size Front
kPa (kgf/cm2, psi)
Rear
kPa (kgf/cm2, psi)
205/60R16 92V 240 (2.4, 35) 230 (2.3, 33)
215/50R17 91V 230 (2.3, 33) 230 (2.3, 33)



b.
C137874

Using a dial indicator, check the runout of the tires.

Maximum tire runout:

1.4 mm (0.0551 in.)



Hide 2. ROTATE TIRES

a.
C163156

Rotate the tires as shown in the illustration.

Text in Illustration
V100135

Front


Hide 3.INSPECT AND ADJUST WHEEL BALANCE

a.
C144018E08
2.044,3.632 2.258,3.800 0.214,0.167 10 (A)

Inspect and adjust the off-the-car balance.

Maximum imbalance:

8.0 g (0.0176 lb)


NOTICE:
·

Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.

·

Do not touch the adhesive surface of the tape.

·

Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

Width (A):

25 mm (0.984 in.)


·

Push the balance weight securely with your finger to adhere it to the desired position.

·

Do not reuse balance weights.



HINT:

The inner side balance weight should be installed by clipping it to the rim.



Hide 4.INSPECT FRONT AXLE HUB AND BEARING

Hide 5.INSPECT REAR AXLE HUB AND BEARING