Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM › 2012.03–2016.05
RM2070E _54 Brake _061923 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0301683 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C1259/58  HV System Regenerative Malfunction  C1310/51  Malfunction in HV system  


DESCRIPTION

The skid control ECU communicates with the power management control ECU and controls braking force according to the motor's regenerative force.

The skid control ECU sends VSC (cooperative control with EPS) signals to the power management control ECU and receives operating signals from the power management control ECU.

The skid control ECU uses CAN communication for communication with the power management control ECU. If a communication malfunction is memorized, the skid control ECU prohibits VSC (cooperative control with EPS) operation and a part of electronically controlled brake system control by fail-safe function.

If the signals from the power management control ECU returned to normal, the warning light will go off and the DTCs C1259/58 and C1310/51 will be cleared.

DTC Code INF Code DTC Detection Condition Trouble Area
C1259/58 - The regeneration malfunction signal is input for at least 0.036 seconds when IG2 terminal voltage is 9.5 V or more for at least 2 seconds and communication with power management control ECU is valid. Power management control ECU
C1310/51 - The internal malfunction signal is input for at least 0.072 seconds when IG2 terminal voltage is 10.5 V or more for at least 2 seconds and communication with power management control ECU is valid. Power management control ECU

HINT:

These DTCs will be output from the skid control ECU when the power management control ECU sends a malfunction signal to the skid control ECU.


PROCEDURE

1.CHECK HYBRID CONTROL SYSTEM
a.

Check if the hybrid control system DTC is output (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC is not output A
DTC is output B




A

B