Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM › 2015.08–2016.05
RM2070E _54 Brake _061923 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0301683 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  42  Electronically Controlled Brake System Malfunction  45  Electronically Controlled Brake System Malfunction  


DESCRIPTION

These DTCs are stored if the ABS and/or VSC system detects a malfunction in the electronically controlled brake system.

DTC Code INF Code DTC Detection Condition Trouble Area
42 - Malfunction in the electronically controlled brake system. Electronically controlled brake system
45 - Malfunction in the electronically controlled brake system. Electronically controlled brake system

CAUTION / NOTICE / HINT

NOTICE:

When replacing the brake booster with master cylinder (skid control ECU), perform initialization and calibration of the linear solenoid valve (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION).


PROCEDURE

1.CHECK ELECTRONICALLY CONTROLLED BRAKE SYSTEM

b.

Turn the power switch on (ready).


c.

Drive the vehicle at a speed of approximately 40 km/h (25 mph) or more for 60 seconds or more.


d.

Check if the same DTC is recorded (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC (Electronically controlled brake system DTC) is not output A
DTC (Electronically controlled brake system DTC) is output B




A

2.RECONFIRM DTC

B

2.RECONFIRM DTC
a.

Turn the power switch off (lock).



c.

Turn the power switch on (ready).


d.

Drive the vehicle at a speed of approximately 40 km/h (25 mph) or more for 60 seconds or more.


e.

Check if the same DTC is recorded (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTCs (42 and 45) are not output A
DTCs (42 and/or 45) are output (for LHD) B
DTCs (42 and/or 45) are output (for RHD) C




A

B

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER

C

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER