Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › SKID CONTROL BUZZER(for RHD) › 2012.03–2014.11
RM2070E _54 Brake _061923 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0301690 SKID CONTROL BUZZER(for RHD) G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  SKID CONTROL BUZZER(for RHD)  INSPECTION  


PROCEDURE

Hide 86652A 1.INSPECT SKID CONTROL BUZZER ASSEMBLY

a.
C181788E32
1.979,0.771 2.26,1.854 false 2.792,0.771 2.479,1.854 false 0.25,0.177 0.469,0.344 0.219,0.167 10 false *a 2.646,0.573 2.948,0.74 0.302,0.167 10 false IG1 1.865,0.573 2.115,0.74 0.25,0.167 10 false BZ 1.24,1.906 1.479,2.104 0.24,0.198 10 false (-) 0.51,1.896 0.75,2.094 0.24,0.198 10 false (+)

Make sure that there is no looseness at the locking part and the connecting part of the connector.


b.

Disconnect the skid control buzzer connector.


c.

Check both the connector case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion.



d.

Connect a negative (-) lead from the auxiliary battery to terminal 1 (BZ), and a positive (+) lead to terminal 2 (IG1) of the skid control buzzer, and then check that the buzzer sounds.

OK:

The skid control buzzer sounds.


Text in Illustration
*a Component without harness connected
(Skid Control Buzzer)

If the result is not as specified, replace the skid control buzzer.