1.REMOVE CYLINDER BOOT
Using a screwdriver with its tip wrapped with vinyl tape, remove the set ring and cylinder boot from the disc brake cylinder.
| *1 | Vinyl Tape |
Be careful not to damage the brake piston or cylinder.
47731
2.REMOVE FRONT DISC BRAKE PISTON
Place a piece of cloth between the front disc brake piston and disc brake cylinder.
Apply compressed air to remove the front disc brake piston from the disc brake cylinder.
Do not place your fingers in front of the piston when using compressed air.
Do not allow any brake fluid to spatter.
3.REMOVE PISTON SEAL
Using a screwdriver with its tip wrapped with vinyl tape, remove the piston seal from the disc brake cylinder.
| *1 | Vinyl Tape |
Do not damage the inner surface or piston seal groove of the cylinder.
31478B
4.REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP
47547B
5.REMOVE FRONT DISC BRAKE BLEEDER PLUG