Home › Brake › BRAKE (FRONT) › FRONT BRAKE FLEXIBLE HOSE › 2012.03–2014.11
RM2070E _54 Brake _061925 BRAKE (FRONT) _0301702 FRONT BRAKE FLEXIBLE HOSE A

BRAKE (FRONT)  FRONT BRAKE FLEXIBLE HOSE  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Because the left and right hoses are not interchangeable, verify the part number when installing the flexible hoses.

·

If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.



HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 47313J 1.INSTALL FRONT FLEXIBLE HOSE

a.
C210937E02
2.4,0.969 2.570,1.121 0.170,0.151 10 *1 1.861,1.058 2.375,1.058 false 1.66,1.553 2.376,1.553 false 2.39,1.455 2.559,1.606 0.170,0.151 10 *a

Install a new clip to the front flexible hose.

Text in Illustration
*1 Clip
*a Identification Mark

NOTICE:
·

Install the clip as far as it will go.

·

When installing the front flexible hose, face the identification mark to the outside of the vehicle and minimize twisting of the hose.




b.

Using a union nut wrench, connect the brake line to the front flexible hose while holding the flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not kink or damage the brake line.

·

Do not allow any foreign matter such as dirt or dust to enter the brake line from the clip or bracket.

·

Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




c.
C210938E03
1.781,0.49 0.708,0.49 true 1.854,0.833 2.583,0.833 true 1.99,0.333 2.198,0.51 0.208,0.177 10 false (A) 1,1.094 1.208,1.271 0.208,0.177 10 true (B) 0.521,0.406 0.677,0.552 0.156,0.146 10 false *1 2.594,0.729 2.781,0.906 0.188,0.177 10 false *2

Install the front flexible hose to the steering knuckle with the bolt (B).

Torque:
19 N*m (192 kgf*cm, 14 ft.*lbf)


d.

Install the front flexible hose and front speed sensor bracket to the absorber bracket with the bolt (A).

Text in Illustration
*1 Front Speed Sensor Bracket
*2 Front Flexible Hose Bracket

Torque:
19 N*m (192 kgf*cm, 14 ft.*lbf)

NOTICE:

Install the front flexible hose first and then the front speed sensor bracket.



e.
C210915

Connect the front flexible hose to the front disc brake cylinder assembly with a new union bolt and a new gasket.

Torque:
30 N*m (310 kgf*cm, 22 ft.*lbf)


Hide 2.FILL RESERVOIR WITH BRAKE FLUID

Hide 3.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 5.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)