Home › Brake › BRAKE (REAR) › REAR BRAKE
RM2070E _54 Brake _061926 BRAKE (REAR) _0301703 REAR BRAKE G

BRAKE (REAR)  REAR BRAKE  INSPECTION  


PROCEDURE

Hide 1.INSPECT BRAKE CYLINDER AND PISTON

a.

Inspect the cylinder bore and the piston for rust or scoring. If necessary, replace the rear disc brake cylinder and piston.


Hide 2.INSPECT PAD LINING THICKNESS

a.
C263976E01
0.591,0.636 0.753,0.788 0.162,0.153 10 *1 1.157,1.003 1.157,0.714 1.157,0.714 0.771,0.714 false

Using a ruler, measure the pad lining thickness.

Text in Illustration
*1 Ruler

Standard thickness:

10.0 mm (0.394 in.)


Minimum thickness:

1.0 mm (0.0394 in.)


If the pad lining thickness is less than the minimum, replace the brake pads.

HINT:

Be sure to check rear disc thickness after replacing the brake pads with new ones.



Hide 3.INSPECT REAR DISC BRAKE PAD SUPPORT PLATE

a.

Make sure that the rear disc brake pad support plates have sufficient rebound, no deformation, cracks or wear, and that all rust and dirt are removed. If necessary, replace the rear disc brake pad support plates.


Hide 4.INSPECT DISC THICKNESS

a.
C232660E01
2.783,1.16 2.946,1.323 0.163,0.163 10 *1 2.538,1.352 2.649,1.241 2.649,1.241 2.766,1.241 false

Using a micrometer, measure the disc thickness.

Text in Illustration
*1 Micrometer

Standard thickness:

12.0 mm (0.472 in.)


Minimum thickness:

10.5 mm (0.413 in.)


If the disc thickness is less than the minimum, replace the rear disc.


Hide 5.INSPECT DISC RUNOUT

a.

Inspect the rear axle hub bearing looseness (See page Drivetrain>AXLE AND DIFFERENTIAL>REAR AXLE HUB>ON-VEHICLE INSPECTION).


b.
C154410E01
0.57,1.789 0.858,1.931 0.288,0.142 10 SST 1.364,1.689 1.261,1.868 1.261,1.868 0.925,1.868 false

Using SST to hold the rear disc, tighten the rear disc with the 5 hub nuts.

SST
09330-00021  

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)


c.
C232659E01
2.411,1.826 2.573,1.989 0.163,0.163 10 *1 1.829,1.581 2.16,1.912 2.16,1.912 2.394,1.912 false

Using a dial indicator, measure the disc runout 10 mm (0.394 in.) away from the outer edge of the rear disc.

Text in Illustration
*1 Dial Indicator

Maximum disc runout:

0.15 mm (0.00591 in.)


NOTICE:

Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.


HINT:

If the runout exceeds the maximum value, change the installation position of the disc to minimize the runout. If the runout exceeds the maximum even when the installation position is changed, grind the disc. If the disc thickness is less than the minimum, replace the rear disc.



d.

Remove the 5 hub nuts and the rear disc.