Home › Brake › BRAKE (REAR) › REAR BRAKE
RM2070E _54 Brake _061926 BRAKE (REAR) _0301703 REAR BRAKE A

BRAKE (REAR)  REAR BRAKE  REASSEMBLY  


PROCEDURE

Hide 47547C 1.TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG

HINT:

Fully tighten the rear disc brake bleeder plug after bleeding any air left in the system.


Hide 31478C 2.INSTALL REAR DISC BRAKE BLEEDER PLUG CAP

Hide 3.INSTALL PISTON SEAL

a.
C211755

Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal.

Text in Illustration
V100155

Lithium Soap Base Glycol Grease


b.

Install the piston seal to the rear disc brake cylinder.

NOTICE:

Securely install the piston seal to the groove of the rear disc brake cylinder.



Hide 47831 4.INSTALL REAR DISC BRAKE PISTON

a.
C236566E01
0.65,0.419 0.811,0.587 0.161,0.168 10 *1 0.65,1.429 0.818,1.590 0.168,0.161 10 *2 1.318,0.498 0.855,0.498 false 1.451,1.497 0.882,1.497 false

Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot.

Text in Illustration
*1 Cylinder Boot
*2 Rear Disc Brake Piston
V100155

Lithium Soap Base Glycol Grease


b.

Install the cylinder boot to the rear disc brake piston.


c.

Apply a light layer of lithium soap base glycol grease to the contact surface of the rear disc brake piston, and install it to the rear disc brake cylinder.

NOTICE:

Do not install the rear disc brake piston forcibly in the rear disc brake cylinder.



Hide 5.INSTALL CYLINDER BOOT

a.
C236549

Install the cylinder boot to the rear disc brake cylinder.

NOTICE:
·

Securely install the cylinder boot to the groove of the disc brake cylinder.

·

Do not damage the cylinder boot.