While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing brake system components, do not depress the brake pedal or open/close the doors while the auxiliary battery is connected.
G9510
1.REMOVE HV BATTERY
2.REMOVE AIR CONDITIONING UNIT ASSEMBLY
46441
3.LOOSEN ADJUSTING NUT
Remove the lock nut and loosen the adjusting nut.
| *1 | Lock Nut |
| *2 | Adjusting Nut |
46302
4.SEPARATE NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY
Separate the No. 1 parking brake pull rod sub-assembly from the parking brake control pedal assembly as shown in the illustration.
| *a | Turn |
| *b | Hold |
46200
5.REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY
Remove the 4 bolts and nut, and separate the No. 1 parking brake cable assembly.
Disengage the 2 wire harness clamps.
Remove the No. 1 parking brake cable assembly from the clamp.
Disconnect the parking brake switch connector.
Disengage the wire harness clamp.
Remove the bolt, 2 nuts and parking brake control pedal assembly.