Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM2070E _55 Steering _061928 POWER ASSIST SYSTEMS _0301712 POWER STEERING SYSTEM U

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Turn the power switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG).


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / EMPS / Data List.


f.

According to the display on the GTS, read the Data List.

EMPS
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Meter Vehicle Velocity Vehicle speed from meter/
Min.: 0.0 km/h (0.0 mph)
Max.: 300.0 km/h (186.4 mph)
0 km/h (0 mph) Power switch on (READY) and vehicle stopped
No significant fluctuation Power switch on (READY) and vehicle driven at a constant speed
Motor Actual Current Amount of current to motor/
Min.: -327.68 A
Max.: 327.67 A
Value changes in proportion to steering effort
- The value rises in left turn
- The value descends in right turn
Power switch on (READY) and steering wheel being turned
Command Value Current Demanded amount of current to motor/
Min.: -327.68 A
Max.: 327.67 A
Value changes in proportion to steering effort
- The value rises in left turn
- The value descends in right turn
Power switch on (READY) and steering wheel being turned
Steering Angle Velocity Steering angle speed/
Min.: -32768 deg/s
Max.: 32767 deg/s
Value changes in proportion to steering speed
- The value rises in left turn
- The value descends in right turn
Power switch on (READY) and steering wheel being turned
Thermistor Temperature ECU substrate temperature/
Min.: -50.0°C (-58.0°F)
Max.: 150.0°C (302.0°F)
-50°C to 150°C (-58°F to 302°F) Power switch on (READY)
PIG Power Supply Power source voltage to active motor/
Min.: 0.0000 V
Max.: 20.1531 V
9 to 16 V Always
IG Power Supply IG power source voltage/
Min.: 0.0000 V
Max.: 20.1531 V
9 to 16 V Power switch on (IG)
Steering Angle Sens Sig Steering angle sensor signal state/
OK or NG(1) or NG(2) or NG(3)
OK: Steering angle sensor signal received
NG(1): Learning has not completed
NG(2): Steering sensor abnormal
NG(3): Communication error
-
Steering Wheel Torque Steering wheel torque/
Min.: -327.68 Nm
Max.: 7.00 Nm
Value changes in proportion to steering effort
- The value rises in left turn
- The value descends in right turn
Power switch on (READY) and steering wheel being turned
Motor Rotation Angle Motor rotation angle/
Min.: 0.000 deg
Max.: 1441.770 deg
During steering operation, motor rotation angle value changes from 0 to 360° Power switch on (READY) and steering wheel being turned
Command Val Current 2 Demanded amount of current to motor/
Min.: -327.68 A
Max.: 327.67 A
Value changes in proportion to steering effort Power switch on (READY) and steering wheel being turned
PIG2 Voltage Coil rear pressurization voltage/
Min.: 0.000 V
Max.: 45.955V
9 to 16 V Power switch on (READY)
Motor Voltage Motor power supply voltage/
Min.: 0.000 V
Max.: 45.955V
Approximately 30 V Power switch on (READY) and steering wheel not being turned
Value changes within 4 to 35 V range Power switch on (READY) and steering wheel being turned
Motor Terminal Volt (U) Motor terminal voltage (U phase)/
Min.: 0.000 V
Max.: 98.000 V
Value changes within 4 to 35 V range Power switch on (READY) and steering wheel being turned
Motor Terminal Volt (V) Motor terminal voltage (V phase)/
Min.: 0.000 V
Max.: 98.000 V
Value changes within 4 to 35 V range Power switch on (READY) and steering wheel being turned
Motor Terminal Volt (W) Motor terminal voltage (W phase)/
Min.: 0.000 V
Max.: 98.000 V
Value changes within 4 to 35 V range Power switch on (READY) and steering wheel being turned
Torque Sensor 1 Output Torque sensor voltage/
Min.: 0.0000 V
Max.: 4.9725 V
2.3 to 2.7 V Power switch on (READY) and steering wheel not turned (without load)
2.5 to 3.8 V Power switch on (READY) and steering wheel being turned to the right with vehicle stopped
1.2 to 2.5 V Power switch on (READY) and steering wheel being turned to the left with vehicle stopped
Torque Sensor 2 Output Torque sensor voltage/
Min.: 0.0000 V
Max.: 4.9725 V
2.3 to 2.7 V Power switch on (READY) and steering wheel not turned (without load)
1.2 to 2.5 V Power switch on (READY) and steering wheel being turned to the right with vehicle stopped
2.5 to 3.8 V Power switch on (READY) and steering wheel being turned to the left with vehicle stopped
TRQ1 Zero Point Value Torque sensor voltage/
Min.: 0.0000 V
Max.: 4.9725 V
Values differ depending on vehicle Power switch on (READY) and steering wheel not being turned
TRQ2 Zero Point Value Torque sensor voltage/
Min.: 0.0000 V
Max.: 4.9725 V
Values differ depending on vehicle Power switch on (READY) and steering wheel not being turned
IG ON/OFF Times Number of times of power switch ON/OFF after fail detection/
Min.: 0 times
Max.: 65535 times
- This value indicates the number of times of power switch ON/OFF after the latest DTC detection.
Motor Overheat Record Continuous overheat prevention control record/
Unrec or Rec
Unrec Unrec: Unrecorded
Rec: Recorded
Motor Lo Power Record PIG power source voltage drop record/
Unrec or Rec
Unrec Unrec: Unrecorded
Rec: Recorded
Eng Rev Inter Record Record of READY ON signal interruption/
Unrec or Rec
Unrec Unrec: Unrecorded
Rec: Recorded
Str Angle Inter Record Record of steering sensor signal interruption occurrence display/
Unrec or Rec
Unrec Unrec: Unrecorded
Rec: Recorded
Spd Sig Invalid Record Record of vehicle speed signal invalid/
Unrec or Rec
Unrec Unrec: Unrecorded
Rec: Recorded
Battery Voltage Lo Record Auxiliary battery voltage reduction history/
Min.: 0 times, Max.: 65535 times
0 to 65535 -
Ready Status Ready status/
OFF or Ready
OFF or Ready -
The Number of DTCs Number of detected DTCs when freeze frame data stored/
Min.: 0
Max.: 255
0 to 255 -