84247A
1.INSTALL STEERING PAD SWITCH LH
Connect the connector to install the steering pad switch LH to the steering pad switch RH.
Align a new clamp with the groove and install it as shown in the illustration.
| *1 | Clamp |
| *a | 70 to 85 mm (2.76 to 3.35 in.) |
| *b | 10 mm (0.394 in.) or less |
| *c | 1 to 3 mm (0.0394 to 0.118 in.) |
|
Front of the Vehicle |
Make sure to install the clamp in the correct direction.
After installation, cut off the excess length of the clamp within the specified range *c shown in the illustration.
2.INSTALL STEERING PAD SWITCH ASSEMBLY
Engage the 2 claws to install the steering pad switch assembly (RH side) to the steering wheel assembly.
Install the 2 screws.
Engage the 2 claws to install the steering pad switch assembly (LH side) to the steering wheel assembly.
Install the 2 screws.
Connect the connector to the spiral cable sub-assembly.
45130
3.INSTALL HORN BUTTON ASSEMBLY