Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR
RM2070E _55 Steering _061930 STEERING GEAR / LINKAGE _0301718 STEERING GEAR G

STEERING GEAR / LINKAGE  STEERING GEAR  INSPECTION  


PROCEDURE

Hide 45047 1.INSPECT TIE ROD END SUB-ASSEMBLY LH

a.
ZK08184

Secure the tie rod end sub-assembly LH in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



b.

Install the nut to the stud bolt.


c.

Flip the ball joint back and forth 5 times.


d.

Set a torque wrench to the nut, turn the ball joint continuously at a rate of 3 to 5 seconds per turn, and check the turning torque on the 5th turn.

Standard turning torque:

1.0 to 3.9 N*m (10 to 39 kgf*cm, 9 to 34 in.*lbf)


If the turning torque is not within the specified range, replace the tie rod end sub-assembly LH with a new one.


Hide 45046 2.INSPECT TIE ROD END SUB-ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 3.INSPECT TOTAL PRELOAD

NOTICE:

Inspect the total preload in a no-load condition by removing the tie rod end sub-assembly RH and LH, and steering rack boots.


a.
C233593E01
2.844,0.584 3.153,0.749 0.309,0.165 10 SST 1.891,0.673 2.828,0.673 false

Install SST to the pinion shaft and turn it left and right 5 times or more.

SST
09616-00011  


b.

Set a torque wrench to SST and turn the pinion shaft continuously at a rate of 4 to 6 seconds per turn to inspect the total preload of the steering gear assembly.

Standard preload:

0.7 to 1.1 N*m (7 to 11 kgf*cm, 6 to 9 in.*lbf)


NOTICE:

Inspect the total preload around the steering rack center position.


If the total preload is not within the specified range, replace the steering gear assembly with a new one.