69284C
1.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
2.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
3.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
74222
4.REMOVE DOOR ARMREST COVER
67602
5.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
86160
6.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY
Disconnect the connector.
Using a drill bit with a diameter of less than 4 mm (0.158 in.), drill out the 4 rivet heads and remove the front No. 1 speaker assembly.
Do not touch the cone part of the speaker.
Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.
Be careful as the cut rivet will be very hot.
Continue drilling and push out the remaining rivet fragments.
Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.