Home › Audio / Visual / Telematics › AUDIO / VIDEO › FRONT DOOR SPEAKER › from 2016.05
RM2070E _56 Audio / Visual / Telematics _061931 AUDIO / VIDEO _0301721 FRONT DOOR SPEAKER A

AUDIO / VIDEO  FRONT DOOR SPEAKER  REMOVAL  


PROCEDURE

Hide 69284C 1.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

Hide 2.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

Hide 3.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

Hide 74222 4.REMOVE DOOR ARMREST COVER

Hide 67602 5.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 86160 6.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

a.
E228601

Disconnect the connector.


b.

Using a drill bit with a diameter of less than 4 mm (0.158 in.), drill out the 4 rivet heads and remove the front No. 1 speaker assembly.

NOTICE:
·

Do not touch the cone part of the speaker.

·

Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

·

Be careful as the cut rivet will be very hot.




c.

Continue drilling and push out the remaining rivet fragments.


d.

Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.